DIY Paint Job Using Nothing But Rattle Cans

Published on 08 Jun 2020 / In Film & Animation

In this video I am going to show you guys how you can paint your car using nothing but rattle cans, we'll go over how to sand and fix scratches and scrapes, spray 2k primer, apply a urethane base coat and than spray 2k clear coat on top. All of that using only rattle cans.

Here are links to products which were used in this video:

220 Grit Sand Paper:
400 Grit Sand Paper:
1500 Grit Sand Paper:
Ultra Fine Grey Scotch Brite Pad:
2K Primer Gray:
BaseCoat: Search for ERA Paints + Your Car's Paint Code on Amzn:
2K Clear Coat:
Grease and Wax Remover:
Masking Tape 1.4" :
Sanding Block:
Tack Cloth:
Microfiber Towels:

Please Consider Supporting My Channel at :


Due to factors beyond the control of Ratchets and Wrenches, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Ratchets and Wrenches assumes no liability for any property or personal damage that may arise from doing a repair on your vehicle after watching any of my repair video's. Due to factors beyond the control of Ratchets and Wrenches, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Again Any injury, damage or loss that may result from improper use of tools, equipment, or the information contained in this video is the sole responsibility of the user and not Ratchets and Wrenches.

Show more
0 Comments sort Sort By